[campcaster-support] Using with Jack
  • Vote Up0Vote Down importimport
    Posts: 0Member
    As I only have 1 sound card in my machine and I want to use it to
    stream, i've been looking at this guide
    http://code.campware.org/projects/campcaster/wiki/campcasterJack .
    Unfortunately, when I enter "jackplug" as my "Live mode audio device" in
    campcaster GUI, I get the following message:

    "Could not get/set settings from/on resource"

    Has anyone managed to use this guide?

    Luke
  • 2 Comments sorted by
  • Vote Up0Vote Down importimport
    Posts: 0Member
    Hi Luke,

    I've followed the steps on the howto exactly as they're written, and
    haven't run into that error.

    However, if you just try to change the value in the live mode output to
    'jackplug' without doing the other steps, then, yes, you'll get the error
    message.

    It's a dumb question, but maybe worth asking: Did you follow all the steps
    as they're written on the howto?


    doug

    Invest in Press Freedom: Visit http://www.mdlf.org/support-free-press
  • Vote Up0Vote Down importimport
    Posts: 0Member
    I've just run through all the steps again but when I try to run

    aplay -D jackplug file.wav

    I get:

    aplay: main:550: audio open error: No such file or directory

    However if I use:

    aplay -D hw:0,0 file.wav

    It plays fine

    Any ideas?

    Luke

    Douglas.Arellanes@mdlf.org wrote:
    > Hi Luke,
    >
    > I've followed the steps on the howto exactly as they're written, and
    > haven't run into that error.
    >
    > However, if you just try to change the value in the live mode output to
    > 'jackplug' without doing the other steps, then, yes, you'll get the error
    > message.
    >
    > It's a dumb question, but maybe worth asking: Did you follow all the steps
    > as they're written on the howto?
    >
    >
    > doug
    >
    > Invest in Press Freedom: Visit http://www.mdlf.org/support-free-press
    >
    >
    >
    >
Add a Comment